Powered Hazardous Location LED Light is an ideal lighting solution for
remote areas and standalone applications where connection to external power is
either impractical or unavailable.
location LED light is powered by two 8aH sealed lead acid batteries
that are recharged by a 30 watt solar panel. Light output comes from a 10
watt LED lamp that produces 1050 lumens. This
solar panel can be equipped with either a dusk to dawn day/night
sensor, a motion sensor, an on/off switch, or configured to run 24/7.
The day/night sensor is programmed to activate the solar panel in the evening
and to shut it off during the day. The motion sensor will activate the
panel upon detecting motion. The on/off switch will activate and shut off the
solar panel according to the operator`s preferences.
light runs for 12 hours when the battery is fully charged. Charging time
for the sealed lead acid batteries is 5 hours when exposed to direct sunlight.
Indirect sunlight will extend the charge time. As with all solar powered
equipment, charging time is affected by the amount of available ambient light.
When ambient light levels drop below a certain level, such as on cloudy days,
the unit will not recharge as quickly. The battery pack is contained within the
solar panel, not the light. The illumination produced by the explosion proof LED
light will cover an area approximately 55’ long x 55’ wide when
mounted 12 feet from the ground. Mounting options include ceiling, wall and
pendant for the lamp fixture and flat surface or round/square pole mounting such
as on utility poles or structure supports for the solar panel.
This hazardous area
light (Lamp Fixture only) is ETL approved Class 1 Division 2, Groups A, B,
C and D. These lights are also compliant with NEMA 4X standards and marine-rated
for use in salt water environments. The high power LED cluster is protected by
an internal cooling fin array that reduces heat build for longer LED life and
higher light output consistency.
location LED light contains an LED bulb that can serve to illuminate small work
areas or draw attention to towers and other structures from a distance. This
C1D2 LED light can be configured for steady burn or strobing applications.
The housing on this LED light is constructed to NEMA 4X standards and is marine
rated for salt water environments. The cast aluminum housing is made of high
strength copper-free aluminum alloy with a baked powder epoxy finish and is
shown with a wall mount configuration, but can be configured with a pendant
or ceiling mount as well. The fixture ships with 30 feet of SOOW
cable and custom lengths are available upon request. Please contact us for
NOTE: Larson Electronics has further upgraded
the options available with this light. We expect the light to be mounted
separately from the panel. This means the solar panel can be mounted in direct
sunlight (not in the hazardous area) while the light is mounted in a
hazardous area workspace. Standard installation for explosion proof
lighting, including threaded rigid pipe to the LED light fixture and appropriate
seal-offs, etc. are required.